How to Program Merlin Garage Remote

Programming your Merlin garage remote is necessary for effective garage door control.

This article will provide a guide to walk you through the precise steps required to program your Merlin remote, ensuring a hassle-free experience every time you access your garage.

Merlin M802 Remote Programming Instructions

1. Remove the battery cover on the Merlin M802 remote
2. Locate DIP switches on the remote and motor head unit
3. Set remote DIP switches to match the ON/OFF pattern of existing remote/motor head unit switches
4. Replace the remote battery cover
5. Stand in range and press the large blue remote button to program
6. Test by pressing a blue button – the door should open/close
7. If unsuccessful, double check DIP switches match strictly between new and old remotes

   

Merlin M842 Remote Programming Instructions

1. Remove the green button cover on the remote to access the receiver board
2. Locate the red “Learn/Delete” button on the receiver board
3. Press and hold the red “Learn/Delete” button until the courtesy LED light flashes
4. Press the sizeable remote button once
5. Press the small remote button once
6. Release the red “Learn/Delete” button
7. Test large and small remote buttons – large opens/closes door, small operates light.

Merlin MT230 Remote Programming Instructions

1. Remove the cover on the motor to access the red “Learn” button
2. Press and hold the “Learn” button until the light flashes
3. Press the large remote button once
4. Press the small remote button once
5. Release the “Learn” button
6. Test remote – large button operates the door, small button operates the light of the motor

Merlin E945 Remote Programming Instructions

1. Remove the white light cover on the motor head to access the receiver board.
2. Press and hold any remote button
3. While holding the remote button, press the orange “Learn” button on the receiver board.
4. Release remote button
5. If programmed correctly, courtesy light flashes
6. Test remote buttons to operate the door
7. If unsuccessful, repeat steps 2-4 to re-sync remote

Merlin M844 Remote Programming Instructions

1. Remove the light cover to access the receiver board.
2. Press and hold the remote button
3. Press the purple “Learn” button on the board while holding the remote button.
4. Yellow LED lights up
5. Release remote button
6. If successful, the yellow LED turns off. Flashing yellow LED means the programming failed.
7. Test remote buttons on the door
8. If unsuccessful, repeat steps 2-5.

Merlin M802 Remote Programming Instructions

1. Remove the battery cover from the current remote or wall-mounted motor head unit.
2. Access the dipswitch bank on the motor head unit if the original remote is unavailable.
3. Remove the battery cover from the replacement remote to expose the internal circuit board.
4. Copy dipswitch combinations (ON or OFF) on the old remote/motor unit.
5. Replicate the dipswitch positions on the new remote using a pen, paper, or phone camera.
6. Ensure the dipswitches on the new remote match those on the old one.
7. Stand in the garage and use the newly programmed remote.
8. Verify that the garage door opener activates properly to confirm successful programming.

Takeaway

Programming your Merlin garage remote is straightforward when following the specific instructions for each model.

Ensuring accuracy in dipswitch configurations and diligently following the outlined steps is key to a successful setup.

By adhering to these instructions, you can confidently control your garage door with the programmed remote, streamlining access and contributing to a trouble-free garage door operation.

At Pittwater Garage Doors, we understand the importance of seamless garage door automation. Our services specialise in addressing issues with remotes, ensuring efficient and reliable operation.

With our expertise, we provide precise solutions to programming and remote-related challenges, ensuring your garage door operates effortlessly for your convenience and security.